- Pickering Interfaces Inc.
product
LXI WTB Extender
60-984-001
The 60-894 provides a simple an effective method of joining two LXI WTB bus cables together to extend the length of available cables. It is an ideal solution for cable extension where users need to experiment with different cabling solutions without having to totally replace the cables in the system. The 60-894 provides mating connectors for the WTB on each end connected together by a set of accurate differential transmission lines to avoid additional reflections on the cable. The 60-894 is entirely passive and is compatible with the LXI specification.
-
product
Experiment Maker
Experiment Maker turns SIGNAL into a programmable, automated, real-time experiment control system by adding capabilities for simultaneous acquisition and playback, microsecond timing and triggering, digital I/O and keyboard control. With SIGNAL and Experiment Maker, the researcher can construct presentation, measurement and control systems that would otherwise require months of programming.
-
product
Rack Mounted SolsTiS System for Cold Atom Experiments
SolsTiS-Rack Mounted
The rack mounted SolsTiS system is designed for the operation of portable cold atom experiments, although it is equally at home in a laboratory where space is limited. The pre-mounted system enables rapid set-up of desired experiments and investigations, minimising downtime due to laser assembly and integration. The system can be customised to your requirements with additional optics packages.
-
product
Graphic Display Module
VIEW-101
The Graphic display module is used to run experimentswithout a PC. It displays the sensor's measurements indigital and graphical forms. It can also be used to program thesensor's experiment setup as well as viewing the input from up tofive sensors at a time.
-
product
Gravimetric Gas/Vapor sorption vacuum analyzer
DVS Vacuum
The DVS Vacuum is designed for single and multicomponent vapor/gas sorption analysis, supporting static and dynamic experiments. The system’s key features are precise control and measure of temperature and pressure while recording the changes in sample mass using high-resolution UltraBalance.
-
product
Handsheet Former
DRKPL6
Shandong Drick Instruments Co., Ltd.
The PL6 handsheet former manufactured by our company is applicable to research and experiments in paper-making research institutes and paper mills. It copies pulp into a sample sheet, then puts the sample sheet on the water extractor for drying and then carries out the inspection of the physical intensity of the sample sheet to appraise the performance of the raw material of pulp and beating process specifications. Its technical indicators conform to China’s specified standard for papermaking physical inspection equipment.
-
product
HF Amplifier
Prometheus
The design of the Prometheus is the result of over 10,000 hours of research and development, encompassing hundreds of hours of mathematical analysis, computer simulation and modeling, and numerous prototypes and experiments spanning over a five year period. The result is a rugged, commercial quality amplifier designed to run cool under 1500W continuous SSB, CW or RTTY, with special ferrite transformers and combiners designed for full power operation even on 160 meters. Although our custom transf...show more -
product
High Current Sensor
HCS-BTA
Vernier Software & Technology, LLC
Use the High Current Sensor in experiments that involve currents larger than 1 A, such as solar panels, hand generators, and other alternative energy projects.
-
product
High Performance Bench Meter for Universal pH Applications
Starter 5000
Backed by OHAUS' century-old commitment to providing precise measurement, Starter 5000 provides accurate pH and ORP measurement for high-level experiments and research. Enhanced features, advanced technology, and high performance have been combined to support complex laboratory tasks requiring pH measurement. Starter 5000's performance is propelled by a 1000 item library, 10 sensors for calibration storage, 8 predefined and 1 self-defined buffer groups, 3 endpoint modes and GLP mode.
-
product
High-Power Pulsed Magnetron-based generators
Pulsed DNP
Insight Product Company offers High-Power Pulsed Magnetron-based generators for pulsed Dynamic Nuclear Polarization (DNP) experiments.
-
product
High Resolution Handheld Infrared Camera
FLIR T650sc
The T650sc infrared camera offers thermal and visual imagery, excellent spot size resolution, and reliable temperature measurement accuracy —all at an affordable price. Technicians, engineers, and scientists will appreciate features such as a built-in digital camera, voice annotation, laser target locator, GPS, Multi Spectral Dynamic Imaging (MSX®), UltraMax™ image enhancement, auto-image rotation, and more. The tiltable IR unit gives you great flexibility and allows you to conduct your experiments fast and in a comfortable position.
-
product
High Resolution Magnet Systems
EPR
EPR samples with S=1/2 electronic spins exhibiting a narrow signal at G=2 and require magnetic fields of only ca. 3.5 T. However, EPR spectra from S>1/2 spins are typically much broader and have spectral features that spread over magnetic field range of several Tesla. Such fields could be easily achieved with superconducting magnets, but, unlike NMR, these magnets cannot operate in a persistent mode in order to satisfy a wide range of resonant fields required by the experiment.
-
product
High Speed High Voltage Amplifier
WMA-320
The WMA-320 is a high voltage, wide bandwidth laboratory amplifier. Its high output voltage, current and wide bandwidth have been designed to serve the needs of a wide variety of high-tech experiments. The WMA-320 can be used for MEMS actuation, EO-modulators, PZT (piezo) positioners, ultrasonics, and many other applications.
-
product
High Speed High Voltage Amplifier
WMA-300
The WMA-300 is a high voltage, wide bandwidth laboratory amplifier. Its high output voltage, current and wide bandwidth have been designed to serve the needs of a wide variety of high-tech experiments. The WMA-300 can be used for MEMS actuation, EO-modulators, PZT (piezo) positioners, ultrasonics, and many other applications. Two WMA-300 amplifiers and a WMA-IB-HS phase inverter - buffer can be used to double the output voltage.
-
product
High Voltage Amplifier
WMA-100A
The WMA-100A model is our cost-effective, compact, general purpose high voltage amplifier. With its high quality and small form factor, it is the ideal choice for any experiment that requires an all-round, reliable high voltage amplifier. It can also be used as a stand-alone low noise high voltage power supply. Two WMA-100A amplifiers and a WMA-IB-HS phase inverter - buffer can be used to double the output voltage.
-
product
High Voltage Pulse Attenuators
Barth High Voltage Pulse Attenuators are matched impedance coaxial attenuators for use primarily in pulsed 50 ohm systems, or where occasional transients would damage ordinary units. The attenuator design closely matches the impedance around each resistor, to that resistor. These attenuators feature an input impedance very close to 50 ohms, with characteristics as good or better than most microwave attenuators. These units are ideal for use in nuclear and high energy experiments. Extensive testing during manufacturing insures very high reliability for single-shot experiments. A voltage coefficient of the resistive film of less than .0001 %/V allows low voltage calibration of most systems.
-
product
HIL and RCP DFIG Laboratory
This laboratory combines the best of both OPAL-RT and Festo solutions to deliver academic researchers and teachers with the ideal Hardware-in-the-Loop (HIL) and Rapid Control Prototyping (RCP) simulation system to conduct experiments and teach in the fields of electrical machinery, power converters and wind energy generation.
-
product
Hot Tack Tester
Guangzhou Biaoji Packaging Equipment Co., Ltd.
GBPI Hot Tack Tester To test the sticking strength of packaging films after heat sealed with different temperature, pressure and time. It simulates the use of packaging bag and makes impact experiment on the part of hot tack.
-
product
Informtest Expert
The software is designed to display and analyze the results of the experiment. The software allows you to view, edit and analyze the signals recorded during the experiment by the Informtest Registrar program. Informtest Expert provides the user with a convenient interface and a wide range of functions and processing algorithms.
-
product
Instrumentation Tutor
Unitech Scales And Measurements Pvt. Ltd
This comprises of temperature and speed using different methods. RTD, thermistor and thermocouple are used as sensors with digital temperature indicator to measure temperature. A small water kettle is supplied as a temperature source upto 100°C. Glass bead thermometer is used as standard temperature measurement source to conduct the experiment. Magnetic and photo reflective sensors are used to measure speed. A FHP motor with speed regulator is used as speed source. To the shaft 60 teeth tone wheels are fixed to generate pulses.
-
product
Integrated Potentiostat System
ER466
The ER466 Integrated Potentiostat System is our most popular potentiostat model, being ideal for cyclic, linear sweep, and most analytical pulse voltammetric experiments, either in the research or teaching laboratory. It also functions as a galvanostat, ZRA (zero resistance ammeter), and high impedance voltmeter (electrometer).
-
product
Inverted Microscope Platform
Axio Observer
In life sciences research you come up against new challenges every day. That’s why you want a flexible microscope system that can be tailored to your needs. ZEISS Axio Observer is your inverse platform for demanding multimodal imaging of living and fixed specimens. Combine Axio Observer with a wealth of technologies and refine it to support your experiments precisely.
-
product
IR Calibration Instruments
Bodkin Design & Engineering, llc
We offer a line of comprehensive solutions to address all of your thermal calibration needs. From bench-top differential sources with .01° C resolution for experiment calibration to built-in OEM devices for on-the-fly thermal reference, Bodkin Design and Engineering and IRBlackbody have the right blackbody for you.
-
product
Isothermal Titration Calorimeters
MicroCal ITC Range
The "Gold Standard" for measuring binding affinity and stoichiometry. MicroCal ITC isothermal titration calorimeters are used to study a wide range of biomolecular interactions. The applications range from drug design to fundamental research such as the understanding and regulation of signal transduction pathways. These systems deliver direct, label free and in-solution measurements of binding affinity and thermodynamic parameters in a single experiment. They have high sensitivity, low sample c...show more -
product
ITCRun, DSCRun, & NanoAnalyze Software
TA Instruments’ feature-rich solution for instrument control, data acquisition, data analysis, and reporting for the Affinity and Nano Series Microcalorimetry products. Designed with intuitive user interfaces, the individual software packages allow for quick creation and execution of experiments and robust analysis of data while maintaining focus on the task at hand.
-
product
Laboratory EM current meter / water level and wave height meter
ACM2-RS and ACM3-RS are 2-D and 3-D electro-magnetic current meters for laboratory experiments. The models provide digital output, a high-speed sampling rate and insusceptibility to electro-magnetic noise. ACH-600RS is a highly sensitive capacitance water level meters. With the new system, a maximum of four different sensors can be connected to the compact interface unit, enabling simultaneous recording on a personal computer. Additionally, the system can provide analog output as well as necessa...show more -
product
Laboratory Equipment
Sample Coffee Roasters
Experiment with one drum or as many as six for side-by-side mini batch comparisons.
-
product
Laboratory Monitors And Controls
Laboratories and life science facilities require high levels of control for safety, occupant comfort, and experiment integrity.
-
product
Laser Instrumentation
We have created a range of high-performance, compact laser instrumentation designed to capture, extract and view important data – making experiments easier to set up, manage and measure. Developed in conjunction with universities, our Ice Bloc system offers state-of-the art connectivity with a modern and accessible interface.
-
product
Laser Scanning Microscopes
The Olympus FLUOVIEW confocal microscopes are designed for high-resolution, confocal observation of both fixed and living cells, enabling visualization deep within samples. From the New FV3000, optimized for the most robust interactive live cell and tissue experiments, to easy-to-use high content imaging, explore the wide range of options with Olympus exclusive optical technologies.
-
product
LED Displays
LED display timer that can be used to time various situations and events such as talent, speakers, presentations, experiments, etc. The LED display has a brightness control and the 0.8" characters are large enough to be read across a room.
